English Deutsch

ERC VERSION 4, USB Kit

ERC VERSION 4, USB Kit
Zoom image

79,00 EUR

19 % VAT incl. excl. Shipping costs

Shipping time: only available at distribution

Product no.: 9-0033
ERC VERSION 4, USB Kit

This product is available through our distributors:

USA and CANADA: VIBROPLEX   

Rest of the World: APPELLO 


Included in the ERC USB kit:

  • Kit with all components to build the ERC USB and to install it inside a rotor-controller
  • USB-cable
  • Instructions how to build the ERC USB
  • Installationguide for more than 90 rotators, have a look to our Rotator Guide
  • Service-Tool (Windows XP/Vista/7/8/10 32 and 64bit) for configuration and calibration.
  • Rotor-Control Software (Windows XP/Vista/7/8/10 32 and 64bit)

There are no rotor-specific connectors or housing included in the kit. You will find connectors for certain rotators in the category Cables&Connectors.

SPECIFICATION ERC USB

  • Size of printed board : 80mm x 61mm
  • Supply-voltage : 11 - 15 VDC, max 110mA, protected against wrong polarization
  • Operating-temperature : 0 to 70°
  • meassuring-circuit for the rotator-feedback-voltage : 0 to +15 V, protected against overvoltage coming through the cable, Input-Impedance > 250 KOhm
  • Resolution : 10bit
  • Software-driven calibration with calibration-assistant
  • Full support for rotators with overlap up to 180°
  • Extended calibration every 30° to compensate non-linearities of the rotator-feedback-voltage
  • Security-stop, if the rotators doesn´t move
  • Relay-circuits:
    • CW/CCW : each 2xON/OFF (DPDT) max 50VAC/3A or 30VDC/2.5A
    • AUX : 1xON (SPST) max. 250VAC at 3A
  • Communication-port: USB (FTDI-chip), baudrate configurable 4800-9600-19200-38400 Baud
  • Controller with bootloader
  • ERC is compatible to a subset of the following protocols:
    • Hygain DCU-1 with extension for position-feedback
    • Yaesu GS232A
    • Yaesu GS232B
  • Programs with which ERC has been checked successfully: see Software-guide
  • Compatible rotators: see Rotator-guide
  • Firmware supported features:
    • delay before rotator starts moving
    • programmable end stops
    • antenna offset
    • overshoot-correction
    • support of overlap up to 180°
    • speed- or brake-function for AUX-output
    • speed function by angle or delay
    • extended Calibration every 30°
    • tolerance of position for tracking-mode
    • software-calibration
    • save and load of all calibration- and configuration-data
  • More details are available in the specification-sheet in the File-section below.

RoHS : ERC and the components used are according to the EG-directive 2002/95/EG to avoid usage of hazardous substances in electronic equipment.

File:

ERC V4 USB Kit Instructions

- only for information
- use the documentation that came with your kit

1.17 MB Download
ERC Specification
22.66 KB Download

This Product was added to our catalogue on Thursday 01 May, 2014.

Shopping cart

You do not have any products in your shopping cart yet.

Welcome back!

E-mail address:
Password:
Forgot your password?

Customer group

Customer group: blocked

Parse Time: 0.125s